Label Placement Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located in the corner closest to the outlet. Some fans may have the model stamped into the motor plate instead of a printed sticker label.

View a sample

Label Placement The data label is located on top corner of the unit housing.

View a Sample

Label Placement Remove the grille by pulling down 2 inches. Reach between the grille and ceiling and squeeze the mounting springs together. Pull springs out of slots in mounting plate. The model label is located on the power unit mounting plate.

View a Sample

Label Placement The model label is located on the cover of the wiring box which is visible from the attic.

View a sample

Label Placement Removed the grille by a central knob or two screws. The model may be ceiling or wall mounted. The label is located on the inside perimeter of housing opposite wiring panel.

View a Sample

Label Placement Remove the bulb(s) from the unit. Remove the springs from the hooks inside the rough-in box. The model number is located on the inside end of the rough-in box.

View a Sample

Label Placement Release the locking tabs on the lens. Remove the lens. Remove the reflector mounting screw. Remove the reflector and grille. The model number is located on the inside edge of the housing.

View a Sample

Label Placement Look through grille for screws and key-hole spots. Loosen screws. Twist complete grille approximately 2 inches. Grille assembly will be free to drop down from ceiling. The model number is located on the inside of the can.

View a Sample

Label Placement Remove 4 screws from the top corners (2 in front & 2 in back). Remove top cover. The model number is located on the data label inside the unit. It can be found in the front right corner.

View a Sample

Label Placement Remove the (2) screws from top and bottom of the grille; on some units you will also need to remove the thermostat knob. Carefully remove complete power unit from rough-in box. The model label is located on the back middle of the rough-in box.

View a Sample

Label Placement The model number is located on top of fan housing.

View a sample